PrintFarm Pricer → Guides → Printers

Anycubic Photon Mono M7 Pro (resin): what it costs to run per hour

A Anycubic Photon Mono M7 Pro (resin) costs about $0.23 per print-hour to operate — machine wear, upkeep and power combined. Far from free, and nowhere near the "$20/hour" folklore. Here is the arithmetic.

What that means for a real print

A 6-hour print on this machine carries about $1.36 of machine cost before filament. Add a typical 8% failure rate and the machine share rises to roughly $1.48 per successful print — failed prints consume hours too. It's a small line next to filament, postage and your own time, but across a month of selling it's real money, and it belongs in your price.

The assumptions, openly

Lifetime is the debatable one. We assume ~4,000 print-hours for this machine — community estimates for resin printers cluster around 3,000–5,000 hours before the screen and film costs dominate. The 90 W figure is an average draw during printing (not the PSU rating, and not the brief heat-up spike). If your numbers differ, change them — every figure is editable.

Price a print on a Anycubic Photon Mono M7 Pro (resin) →

That link opens the calculator with this printer's price, wattage and lifetime already filled in.

Related

What 3D printing actually costs per hour · Etsy fees for 3D print sellers

Figures use the 2026 US average electricity rate ($0.18/kWh) and a $0.07/print-hour maintenance estimate — every assumption is editable in the calculator. Estimates, not accounting advice.